454 NT7D16 Data Access card
The following keyboarddialing features are suppor ted with the DAC:
•Autobaud from 110 to 19200 bps
•Autoparity to ensure that the keyboard dialing menu is readable on the
data terminal during the interactive dialogue mode
•Originating calls to local and remote hosts
•Ring Again
•Speed Call
•Twoanswer modes for incoming calls: manual and auto
•Digit display
•Dialing by mnemonic
Initiating conditions
In order for the DACto respond to user commands/entries, the following
conditions must be met:
•The DAC mustbe active (power ON), and successfully receive the
downloaded parameters from the system.
•The user equipment must be active, and, if in RS-232-C mode, must
assert these control lines
— DCE mode: DTR (unless Forced DTR has been software selected)
— DTE mode: RI has cycled the appropriate number of times
Echo During call setup (dialogue phase), all user input is echoed back to the
user equipment. Once the call is established, the DAC is transparent to
data communication. To get echoed characters after a call is established,
the far end must provide the echo.
Note: When RS-232-C modes 12-15 (Host modes) are selected, there
is no echo during dialogue phase.
Prompts
Call processing prompts are in upper case letters only. Other prompts
consist of both upper and lower case characters, and the dialogue session
depicts the actual upper/lower case letters used.
All prompts are preceded by the Carriage Return and Line Feed ASCII
characters (<CR>, <LF>).
Prompts requesting user input are terminated with the ASCII colon (:).
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.