1100 QPC513 Enhanced Serial Data Interface card
Mode Port Jumper socket
designations
Data communication equipment (DTE) 2UA17 UA19
Data terminal equipment (DCE) 2UA16 UA18
Table449
ESDI card RS-232-C/high-speed interface jumper settings
Mode Port Jumper socket
designations
RS-232-C interface 1UB9 UB11
High-speed interface 1UB10 UB12
RS-232-C interface 2UB16 UB18
High-speed interface 2UB17 UB19
Software service changes
All of the other ESDI port operating parameters are defined in software and
downloaded to the assigned ESDI port. See Table 443 "Characteristics
of synchronous ports" (page 1093). These changes are made using the
Configuration Record program (LD 17). Instructions for the Configuration
Record program are found in the Software Input/Output Reference —
Administration (NN43001-611).
Some of the prompts that are commonly used when running the
Configuration Record program (LD 17) are shown in Table450 "LD 17 -
Serial port configuration parameters." (page 1100) These parameters must
be set for each ports if both ports are being used.
Table450
LD 17 - Serial port configuration parameters.
Prompt Response Description
REQ: CHG Change configuration.
TYPE: CFN Configuration type.
IOTB YES Change input/output devices.
ADAN NEW TTY x
NEW PRT x
Define a new system terminal (printer) port as device x, where x
= 0 to 15.
CDNO 1-16 Use the ESDI card number to keep track of all ports.
DENS DDEN Double density SDI paddle board.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.