Installation and configuration 189
5Configure the Lineside T1 card through the system software and
verify self-test results.
6Verifyinitial T1 operation and configure MMI (optional).
—End—
Steps 1-5 are explained in this section. Step 6 is covered in "QPC43
Peripheral Signaling card" (page 104).
Installation and configuration of the Lineside T1 card consists of six basic
steps:
Step Action
1Configure the dip switches on the Lineside T1 card for the
environment.
2Install the Lineside T1 card into the selected card slots in the IPE
shelf.
3Cable from the I/O panel to the Customer Premise Equipment
(CPE) or CSU, MMI terminal or modem (optional), external alarm
(optional), and other Lineside T1 cards for daisy chaining use of
MMI terminal (optional).
4Configure the MMI terminal.
5Configure the Lineside T1 card through the Meridian 1 software
and verify self-test results.
6Verifyinitial T1 operation and configure MMI (optional).
—End—
Steps 1-5 are explained in this section. Step 6 is covered in "Functional
description" (page 391).
Dip switch settings
Begin the installation and configuration of the Lineside T1 card byselecting
the proper dip switch settings for the environment. The Lineside T1 card
contains two dip switches, each containing eight switch positions. They are
located in the upper right corner of the motherboard circuit card as shown
in Figure 32 "Lineside T1 card - T1 protocol dip switch locations" (page
191). The configuration for these switches are shown in Table 87 "Lineside
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.