468 NT7D16 Data Access card
Table183
Allowable S registers
S register Range Range units Supported Description
S0 0–255 Rings Yes Number of rings to answer a system call (0
= manual answer)
S1 0–255 Rings Yes Ring count for the current inbound system
call
S2 0–127 ASCII Yes Off-line escape sequence character
S3 0–127 ASCII Yes Input/output line terminating character
S4 0–127 ASCII Yes New line character for the output line
S5 0–32,
127 ASCII Yes Backspace character for input/output lines
S6 2–255 Seconds No Wait time before blind dialing
S7 1–255 Seconds Yes Timeouttimer for far end answering
S8 0–30 Seconds Yes Durationfor the dial pause character
S9 1–255 0.1 second No Carrier detect response time
S10 1–255 0.1 second No Delay time between loss of carrier and call
release
S11 50–255 Milliseconds No Touch tone spacing
S12 20–255 20 millisec
onds Yes Guard time for the escape sequence
Youcan view any of the S registers by issuing the following display
command. Any S register can be specified through the ATS command,
and the system displays the current setting for that parameter. More than
one S register can be viewed by listing the desired registers on the same
command line.
One registerTworegisters
ATS8? ATS8? S9
20
OK 002
006
OK
Tochange any S register range, except S1, use the following change
command. The new parameters remain in effect until another change
command is given or the HayesReset modem command (Z) is issued. If
the DACis powered up, the parameters are reset to the defaults.
ATS8 = 15
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.