Nortel Networks 311 E and M Type I signaling

748 NT8D15 E and M Trunkcard
Figure 239
Signaling orientation for tandem connection betweenE and M and CO trunks
The information in this section describes the signaling and call control of E
and M TypeI and II trunks. The call is terminated and the trunk released by
a disconnect message sent to the associated unit.
Figure 242 "Signaling orientation for tandem connection between E and M
and CO trunks" (page 752) shows the E and M Trunk signaling orientation
for a tandem connection between E and M and CO trunks.
The information in this section describes the signaling and call control of E
and M TypeI and II trunks. The call is terminated and the trunk released by
a disconnect message sent to the associated unit. Figure 247 "Signaling
orientation for tandem connection between E and M and CO trunks" (page
765) shows the trunk signaling orientation for a tandem connection between
E and M and CO trunks.
E and M Type I signaling
Figure 240 "E and M TypeI signaling patterns - originating party release"
(page 750) shows E and M TypeI signaling patter ns for incoming and
outgoing calls. Figure 241 "E and M Type I signaling patterns - originating
party release on a tandem connection" (page 751) shows Type I signaling
patterns on a tandem connection where the originating end is senderized
and the route is over a CO trunk (not applicable to CCSA).
Figure 243 "E and M TypeI signaling patterns - originating party release"
(page 753) shows E and M TypeI signaling patter ns for incoming and
outgoing calls. Figure 244 "E and M Type I signaling patterns - originating
party release on a tandem connection" (page 754) shows Type I signaling
patterns on a tandem connection where the originating end is senderized
and the route is over a CO/FX/WATStrunk (not applicable to CCSA).
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.