756 NT8D15 E and M Trunkcard
— In wink start mode, within a 128–256 ms period after receipt of the
seizure signal from the far-end, the called office transmits a 250 ms,
wink start, off hook/on hook signal to the calling office.
Table271
Operation mode
Operation mode Start arrangement
Immediate start IMM
Delay dial DDL
Wink start WNK
The far-end initiates calls as follows:
•The ground is placed on the E lead inE and M signaling.
•Dial pulses are subsequently applied from the far-end as ground open
on the E lead.
•If the far-end is equipped forsending, the system can operate in any
mode (immediate start, delay dial, or wink start), as assigned on a start
arrangement basis. See Table 272 "Operation Mode" (page 756).
— In immediate start mode, there is no start signal from the called
office. The seizure signal (off hook supervisory state) from the
far-end should be at least 150 ms. At the end of the seizure signal,
the far-end can start pulsing after the standard delay (normally 70
ms minimum).
— In delaydial mode,a 256–384 ms off hook/on hook signal is returned
to the far-end immediately after receipt of the seizure signal. When
the far-end detects the on hook signal (start signal), the far-end can
start pulsing after the standard delay (normally 70 ms minimum).
— In wink start mode, within a 128–256 ms period after receipt of the
seizure signal from the far-end, the called office transmits a 250 ms,
wink start, off hook/on hook signal to the calling office.
Table272
Operation Mode
Operation mode Start arrangement
Immediate start IMM
Delay dial DDL
Wink start WNK
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.