Configuring the QSDI paddle board 827
Table323
NT8D41BA address switch settings
SW15 Port 1 Port 2 Switch settings
SW16 Port 3 Port 4 1* 2+34
5678
01
E X off off off off off off
Device 23
E X off off off off off on
45E X off off off off on off
pair 67E X off off off off on on
89
E X off off off on off off
addresses 10 11 E X off off off on off on
12 13 E X off off off on on off
14 15 E X off off off on on on
* To enable ports 1 and 2, set SW15 position 1 to ON. To enable ports 3 and 4, set SW16 position 1
to ON.
+For each X, the setting for this switch makes no difference, because it is not used.
DTE/DCE/Fiber mode
Each serial port can be configured to connect to a terminal (DTEequipment), a modem (DCE equipment), or a Fiber Superloop Networkcard. Instructions for setting the switches SW2, SW3, SW4, SW5, SW6,SW7, SW8, and SW9 are shown in Table324 "NT8D41BA DTE/DCE/Fiberswitch settings" (page 827).Figure 270 "NT8D41BA QSDI paddle board"(page 823) shows the location of these switches on the paddleboard.
Table324
NT8D41BA DTE/DCE/Fiber switch settings
Port 1 — SW 3 Port 1 — SW 2
Mode 1 2 3 456123456
DTE (terminal) on on on off on off off on off on off on
DCE (modem) off off off on off on on off on off on off
NT1P61 (Fiber) on on on on on off on on on off on off
Port 2 — SW 5 Port 2 — SW4
DTE (terminal) on on on off on off off on off on off on
DCE (modem) off off off on off on on off on off on off
NT1P61 (Fiber) on on on on on off on on on off on off
Port 3 — SW 7 Port 3 — SW 6
DTE (terminal) on on on off on off off on off on off on
DCE (modem) off off off on off on on off on off on off
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.