Physical description 931
Table384
Switch SW2
Cable Type SW 2-1 SW 2-2
75 ohms Up (Off) Down(On)
120 ohms Down (On) Up (Off)
Switch SW3 - Clock Controller Configuration
This switch enables/disables(H/W) the on-board Clock Controller. Disable
the SW 3-2 if the on-board clock controller is not in use.
Table385
Switch SW3
Switch Down (On) Up (Off) Note
SW 3-1 ——Spare
SW 3-2 Disabled Enabled
Switch SW4 - Carrier Shield Grounding
This switch enables forthe selective grounding of the Tx / Rx pairs of the
carrier cable. Closing the switch (down position) applies Frame Ground
(FGND) to the coaxial carrier cable shield, creating a 75 ohms unbalanced
configuration. This applies only to the NTBK05CA cable.
Table386
Switch SW4
Switch Down (On) Up (Off)
SW 4-1 Rx– FGND Rx – OPEN
SW 4-2 Tx– FGND Tx – OPEN
Note: The usual method is to ground the outer conductor of the receive
coaxial signal.
Power requirements
The NTAK79obtains its power from the backplane, drawing maximums of 2
A on +5 V,50 mA on +12 V and 50 mA on –12 V.
The NTAK79obtains its power from the backplane, drawing maximums of 2
amps on +5 V,50 mA on +12 V and 50 mA on -12 V.
The NTAK79obtains its power from the backplane, drawing maximums of 2
A on +5 V,50 mA on +12 V and 50 mA on –12 V.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.