68 Circuit card installation
Figure 16
Installing the circuit card inthe card cage
7Insert the card into the card aligning guides in the card cage. Gently
push the card into the slot until you feel resistance. The tip of the
locking devicemust be behind the edge of the card cage (see Figure
16 "Installing the circuit card in the card cage" (page 68)).
8Lock the card into position by simultaneously pushing the ends of
the locking devices against the faceplate.
Note: When IPE cards are installed, the red LED on the
faceplate remains lit for two to five seconds as a self-test runs.
If the self-test is completed successfully, the LED flashes three
times and remains lit until the card is configured and enabled
in software, then the LED goes out. If the LED does not follow
the pattern described or operates in any other manner (such as
continually flashing or remaining weakly lit), replace the card.
9If there is an enable/disable switch, set it to Enb.
Note: Do not enable the switch on an NT8D04 Superloop
Network card or QPC414 Network card until network loop cables
are installed.
10 If youare adding avoice, conference, or tone and digit loop, press the
manual initialize (Man Int) button on the NT5D03 or the NT5D10 Call
Processor if the card is associated with the active Call Processor:
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright© 2003-2008, Nor tel Networks
.