Physical description 881
LED State Definition
Off No far end alarm.
LBK On (Yellow) NTAK10 is in loop-back mode.
Off NTAK10 is not in loop-back mode.
CC On (Red) The clock controller is switched on and disabled.
On (Green) The clock controller is switched on and is either locked to a reference
or is in free-run mode.
Flashing (Green) The clock controller is switched on and locking onto the primary
reference.
Off The clock controller is switched off.
Note: See "Clock controller interface" (page 894) in this chapter for
more on tracking and free-run operation.
The 2Mb DTI pack uses a standard IPE-sized (9.5" by 12.5"), multilayer
printed circuit board. The faceplate is 7/8" wide and contain six LEDs.
In general, the LEDs operate as follows:
•after the card is plugged in, the LEDs (a-e) are turned on by the
power-up circuit. The clock controller LED is independently controlled
by its own microprocessor
•after initialization, the LEDs (a-e) flash three times (0.5 seconds on,
0.5 seconds off) and then individual LEDs go into appropriate states,
as shown in Tabl e.
Table365
NTAK10LED states
LED State Definition
DIS On (Red) The NTAK10 circuit card is disabled.
Off The NTAK10 is not in a disabled state.
OOS On (Yellow) The NTAK10 is in an out of service state
Off The NTAK10 is not in an out of service state
NEA On (Yellow) A near end alarm state has been detected
Off No near end alarm
FEA On (Yellow) A far end alarm state has been detected
Off No far end alarm
LBK On (Yellow) NTAK10 is in loop-back mode
Off NTAK10 is not in loop-back mode
CC On (Red) The clock controller is switched on and disabled
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23May 2008
Copyright© 2003-2008, Nor tel Networks
.