[17] Selecting the input mode

Note: You can also select the input mode from the ‘Custom’ section (if this setting has been defined for this).

Specify the zoom factor

You can use the ‘Zoom’ setting to select a zoom factor. If you select ‘Automatic’ with the ‘’ symbol, the Océ TDS600 Copier will use a zoom factor that is needed to obtain a copy without loss of information. This will be done according to the selected media roll or sheet feeder. After inserting the original, the zoom factor that is used is indicated by the ‘’ symbol.

If you select the numeric zoom factor with the ‘’ symbol, you can define a zoom factor yourself between 25% and 400%. After selecting the numeric zoom factor, the four little triangles will appear to the right. Now you can define a new zoom factor in two different ways:

By using the Arrow buttons on the right of the display (see figure 10 on page 41). If you press one of the vertical buttons, the zoom factor will increase or decrease with steps of 0.1%. If you press one of the horizontal buttons, the zoom factor will increase or decrease with the steps predefined in the Océ Settings Editor by the key operator.

By using the numeric buttons at the bottom of the operator panel. You can specify the exact zoom factor with 0.1% increments.

For example, if you want to specify a zoom factor of 25.4%, you type 254. If you want to specify a zoom factor of 254%, you type 2540.

Selecting the zoom factor

1Select the ‘Image’ card in the ‘Copy’ section.

2Select the desired media with the ‘Zoom’ function button.

50

Océ TDS600 Multifunctional Digital System User Manual

Page 50
Image 50
Oce North America TDS600 user manual Specify the zoom factor, Selecting the zoom factor