8Make certain that at least 200 mm (2 strip lengths) of tape protrude from the knife section (see figure 149).

[149] Protruding tape

9The holes in the tape must be aligned with the hole pattern on the sticker you can find on the frame plate of the reinforcement unit (see figure 150). If this is not the case, you lift the tape from the pin roller and push the tape further between the two knives until the holes are aligned.

[150] Adjusting the holes on the tape

258

Océ TDS600 Multifunctional Digital System User Manual

Page 258
Image 258
Oce North America TDS600 user manual 258