OcéPower Logic: Settings Editor(for the system administrator) 213
Calcomp
Setting Description
EnableCal-
comp
The 'Enable' option allows youto enable or disable Calcomp. In
caseof problems with Calcomp, the Calcomp PDL can be disabled
bys electing the 'Disabled' option.
Stepsize The'Step s ize'op tionall owsyou to define the number of steps per
inch. Note: This setting should correspond with the resolution o f
the plot.
Origin Withthe 'Origin' option you can define the Calcom p origin settings
of the plot.
Synchro
code
Youcan use the 'Synchro code' option to define the character code
for the synchronization byte. This setting indicates the beginning
of the plot data.
Double syn-
chro
Youcan use the 'Double synchro'option to enable / disable the
doublesync mechanism.
Checksum Youcan use the 'Checksum' option to enable / disable the check-
sum.
End of mes-
sage
Youcan use the 'End of message' option to define the character
code for the end-of-message by te. This will indicate the end of a
datasequence.
Penpriority Pen parameters can bedefined in two ways:
- In the plot data file
-In the Remote ConfigurationFile (RCF) or Océ JobTicket (OJT)
Ifpen priority is set to 'Language', the pen parameters definedin
the plot data file will be used. If pen priority is set to 'Setup', the
penparameters defined in the configuration file or the job ticket re-
ceivedwith th eplo t will be used.
Colour
mergecon-
trol
Youcan use the 'Colour merge control'option to determine what
happenswhen two or more colours intersect at the same point on a
plot, especially at the intersection of vectors or 'filled' polygons.
Ift he Colour merge control i sse t to 'Off', the Colour of th e last vec-
toror area fill overwrites the colours specified at the same crossing
area.White areas are consideredopaque. If set to 'On', all colours
areb lended together (merged) at the intersection of vectors and
polygons.
Penwidth
scaling
Toenable or disable the pen width scaling.
If enabled: scaling an image will scale the pen width correspond-
ents.