Oce North America TDS600 Set folding legend, Set the drawing method, Set the folded package width

▼Set folding legend

1Press the ‘Feeding’ card in the ‘Original’ section.

2Press the function button ‘Legend location’.

3Select ‘Leading’ or ‘Trailing’.

In the drivers, this setting is called the ‘Folding orientation’, with the options ‘Portrait’, ‘Landscape’ and ‘Automatic’.

▼Set the drawing method

1Press the ‘Feeding’ card in the ‘Original’ section.

2Press the function button ‘Drawing method’.

3Select ‘Standard’, ‘Ericsson’ or ‘Afnor’.

▼Set the folded package width

1Press the ‘Finishing’ card in the ‘Print’ section.

2Press the function button ‘Folded package’.

3Select ‘Width’.

Enter a range between 186 - 230 mm in steps of 1 mm; default 210 mm.

▼Set the folded package length)

1Press the ‘Finishing’ card in the ‘Print’ section.

2Press the function button ‘Folded package’.

3Select ‘Length’.

4Enter a range between 276 - 310 mm in steps of 1 mm; default 210 mm

▼Set the binding edge

1Press the ‘Finishing’ card in the ‘Print’ section.

2Press the function button ‘Binding’.

3Select binding enabled or disabled.

4If you selected enabled enter a range between 15 - 30 mm in steps of 1 mm; default 20 mm.

▼Set the reinforcement

1Press the ‘Finishing’ card in the ‘Print’ section.

2Press the function button ‘Binding’.

3Select ‘Reinforce’ enabled or disabled.

You can overrule the standard folding program with settings from the printer driver or the scanner operating panel.

See ‘Standard folding settings’ on page 290 for complete information about defining default folding settings.

The folder 291