Oce North America TDS600 user manual Guide

guide

release

handles

view holes

[134] Adjusting the position of the right hand guide

3Remove the packaging of the print material. In case of wrapped paper, also remove the top and bottom sheets.

Note: If you use polyester as print material you have to fan the sheets before you load them to avoid that they stick together.

4Position the print material in the drawer against the front plate. The side to be printed should be facing downwards.

Note: You can check if the material is properly loaded by looking through the view holes in the drawer (see figure 134).

5Adjust the right hand guide.

Note: Carefully place the print material in the drawer to avoid damage to the media.

6Slide the two other guides into position. Also refer to the sticker inside the drawer.

7Close the drawer.

Note: When you alter the size and/or media type, you have to adjust the settings on the operating panel.

Attention: If you decide to reload print material when the drawer is not entirely empty, it is recommended to remove all remaining print material from the drawer before you insert the new print material. This way you can avoid the risk of inadvertently shifting any remaining print material out of place and blocking the path. This could result in a jam.

Media and supplies 247