Oce North America TDS600 user manual Feed/cut

8Use both hands to slide the material under the metal paper guide until it makes contact, as shown in figure 129.

[129] Using both hands to load the material

Note: When the print material is particularly curled it may be somewhat difficult to slide the material under the paper guide. In that case you can slightly fold back the top few centimetres (no more than 10) of the print material to facilitate the load process.

9Press the appropriate green button inside the paper roll compartment (see figure 130). The material will automatically be fed into the machine. Also refer to the sticker inside the drawer.

Feed/cut

buttons

[130] Button for feeding and cutting the paper

10Press the green button a second time to cut off the material protruding from the paper path.

11Remove the scrap material.

12Close the roll compartment.

13Press the on line button to put the system off line.

Media and supplies 243