
3Com Router 5000/6000 Family | 103 |
Command Reference |
|
nat outbound static
Use the nat outbound static command to apply on the interface
Interface view
nat overlapaddress
Use the nat overlapaddress command to map an overlapping address pool to a temporary address pool.
System view
nat server
Use the nat server command to define a mapping table for internal servers. Users can access the internal server with the address and port as
Interface view
nat static
Use the nat static command to configure a
System view
nat static inside
Use the nat static inside command to create a static
System view
nat traversal
Use the nat traversal command to configure the NAT traversal function of IKE/IPSec.
IKE-Peer view
Use the
CE3 Interface view
Use the
System view
Use the
DHCP Address Pool view
nesting
Use the nesting command to configure a nesting rule.
ACL view
Use the
DHCP Address Pool view
network
Use the network command to configure the network routes advertised by the local BGP system.
BGP view
network
Use the network command to configure an IP address range used for dynamic allocation.
DHCP Address Pool view
network
Use the network command to configure the network addresses to be sent by the local BGP.
IPv4 Multicast Subaddress Family view
network
Use the network command to configure the interface running OSPF.
OSPF Area view
network
Use the network command to enable Routing Information Protocol (RIP) on the interface.