3Com 5000/6000 manual User view, Class view

3Com Router 5000/6000 Family	77
Command Reference

hwatacacs change-password self

Use the hwtacacs change-password self command to enable the TACACS online user to change the password.

User view

hwatacacs nas-ip

Use the hwtacacs nas-ipcommand to specify the source address of the hwtacacs packet sent from NAS.

System view

hwatacacs scheme

Use the hwtacacs scheme command to enter TACACS+ Server view. If the specified TACACS+ server scheme does not exist, you can create a new TACACS+ scheme.

System view

hwping

Use the hwping command to create an HWPing test group.

System view

hwping-agent enable

Use the hwping-agent enable command to enable the HWPing client function.

System view

hwping-agentmax-requests

Use the hwping-agentmax-requestscommand to set the allowed maximum number of concurrent tests.

System view

hwping-server enable

Use the hwping-server enable command to enable HWPing Server.

System view

hwping-server tcpconnect

Use the hwping-server tcpconnect command to create a TCP listening service.

System view

hwping-server udpecho

Use the hwping-server udpecho command to create a UDP listening service.

System view

icmp redirect send

Use the icmp redirect send command to enable the sending of ICMP Redirect messages.

System view

id-type

Use the id-typecommand to select the type of ID used in IKE negotiation.

IKE-Peer view

idle-mark

Use the idle-markcommand to set the line idle-mark of the synchronous serial interface to “FF”.

Synchronous Serial Interface view

idle-timeout

Use the idle-timeoutcommand to set the idle-timeout timer. When it expires, the user connection is disconnected.

User Interface view

idlecode (CE1/PRI Interface)

Use the idlecode command to set the line idle code on the CE1/PRI interface. Two types of line idle code are available: 0x7e and 0xff.

CE1/PRI Interface view

idlecode (CT1/PRI Interface)

Use the idlecode command to set the line idle code on the CT1/PRI interface. Two types of line idle code are available: 0x7e and 0xff.

CT1/PRI Interface view

if-match

Use the if-matchcommand to define the match rule of a class.

Class view

if-match acl

Use the if-match acl command to define ACL match rule.

Class view

if-match acl

Use the if-match acl command to set conditions that multicast packets should meet in each policy node.

Route-Policy view