3Com 5000/6000 manual Interface including the MFR Interface view

120	3Com Router 5000/6000 Family
	Command Reference

qos lr

Use the qos lr command to limit the transmitting rate of the interface.

Interface (including the MFR Interface) view

qos max-bandwidth

Use the qos max-bandwidthcommand to configure the maximum interface bandwidth used when CBQ enqueues packets.

Interface view

qos policy

Use the qos policy command to define a policy and enter policy view.

System view

qos pq

Use the qos pq command to apply a group of priority list to an interface.

Interface view

qos pql default-queue

Use the qos pql default-queuecommand to designate the packets without corresponding rules to a default queue.

System view

qos pql inbound-interface

Use the qos pql inbound-interfacecommand to establish classification rules based on interfaces.

System view

qos pql protocol

Use the qos pql inbound-interfacecommand to establish classification rules based on interfaces.

System view

qos pql queue

Use the qos pql queue command to specify the maximum number of packets that can wait in each of the priority queues, or the length of a PQ.

System view

qos pql protocol mpls exp

Use the qos pql protocol mpls exp command to establish the classification rule based on MPLS protocol.

System view

qos reserved-bandwidth

Use the qos reserved-bandwidthcommand to set the maximum reserved bandwidth percentage.

Interface view

qos rtpq

Use the qos rtpq command to enable RTP queue feature on an interface so as to reserve a real-time service for the RTP packets sent to some UDP destination port ranges.

Interface view

qos wfq

Use the qos wfq command to apply WFQ to and configure WFQ parameters on the interface or modify

WFQ parameters on the interface.

Interface view

qos wred

Use the qos wred command to apply WRED at an interface.

Interface view

qos wred dscp

Use the qos wred dscp command to set the lower limit, upper limit, and drop probability denominator of a

WRED DSCP.

Interface view

qos wred ip-precedence

Use the qos wred ip-precedencecommand to configure the minimum threshold, maximum threshold and drop probability denominator for each precedence level in WRED.

Interface view

qos wred weighting-constant

Use the qos wred weighting-constantcommand to set exponential used to calculate the average length of WRED queues.

Interface view

radius nas-ip

Use the radius nas-ipcommand to specify the source address of the RADIUS packet sent from NAS.

System view