3Com 5000/6000 manual Isdn Interface view, Isdn BRI Interface view Isdn PRI Interface view

3Com Router 5000/6000 Family	89
Command Reference

ipx split-horizon

Use the ipx split-horizoncommand to enable split horizon on the current interface.

Interface view

ipx tick

Use the ipx tick command to configure the delay of interface sending IPX packets.

Interface view

ipx update-change-only

Use the ipx update-change-onlycommand to enable trigger update on the current interface.

Interface view

is-level

Use the is-levelcommand to configure the IS-IS level.

IS-IS view

isdn bch-local-manage

Use the isdn bch-local-managecommand to enable local ISDN B channel management.

ISDN Interface view

isdn bch-select-way

Use the isdn bch-select-waycommand to set a B channel selection method.

ISDN Interface view

isdn caller-number

Use the isdn caller-numbercommand to configure the range of the numbers that the router can receive.

ISDN Interface view

isdn calling

Use the isdn calling command to have the messages from a calling party to a called party carry the calling number.

ISDN Interface view

isdn check-called-number

Use the isdn check-called-numbercommand to configure the called number or subaddress that the system should verify when receiving a digital call.

ISDN BRI Interface view

ISDN PRI Interface view

isdn crlength

Use the isdn crlength command to set length of the call reference used when a call is placed on an ISDN interface.

ISDN Interface view

isdn ie passthrough

Use the isdn ie passthrough command to enable transparent transmission of some or all related information elements and you can use this command to configure transparent transmission direction.

ISDN Interface view (not applicable on BRI Interface)

isdn ignore connect-ack

Use the isdn ignore connect-ackcommand to configure the router to switch the ISDN protocol state to ACTIVE to start the data and voice service communications after sending a CONNECT message without having to wait for a CONNECT ACK message.

ISDN Interface view

isdn ignore hlc

Use the isdn ignore hlc command to disable ISDN to carry the higher layer compatibility (HLC) information element in the SETUP messages sent when placing voice calls.

ISDN Interface view

isdn ignore llc

Use the isdn ignore llc command to disable ISDN to carry the Lower Layer Compatibility (LLC) information element in the SETUP messages sent when placing voice calls.

ISDN Interface view

isdn ignore sending-complete

Use the isdn ignore sending-completecommand to configure the ISDN protocol to ignore the processing on the Sending Complete Information Element.

ISDN Interface view

isdn L3-timer

Use the isdn L3-timercommand to configure the duration of an ISDN L3 timer.

ISDN Interface view