3Com Router 5000/6000 Family | 87 |
Command Reference | |
| |
ip vpn-instance | |
Use the ip vpn-instancecommand to create and configure a vpn-instance. | |
Use the ip vpn-instancecommand to create a vpn-instance named vpn-name. | |
|
| Routing Protocol (BGP and RIP) view |
ipsec card-proposal
Use the ipsec card-proposalcommand to create an SA proposal for the encryption card and enter the corresponding view.
ipsec policy (Interface view)
Use the ipsec policy (Interface view) command to apply an ipsec policy group with the name policy-nameat the interface,.
ipsec policy (System view)
Use the ipsec policy command to establish or modify an ipsec policy, and enter IPSec policy view.
ipsec policy-template
Use the ipsec policy-templatecommand to establish or modify an IPSec policy template, and enter
IPSec policy template view.
ipsec proposal
Use the ipsec proposal proposal-namecommand to establish or modify a proposal named proposal-name, and enter IPSec proposal view.
ipsec sa global-duration
Use the ipsec sa global-durationcommand to set a global SA duration.
ipv4-family
Use the ipv4-familycommand to enter IPv4 extended address family view of BGP.
Use the ipv4-family multicast command to multicast. For relevant contents, refer to "MBGP Multicast
Extended" chapter in module "Multicast" of this manual.
Use the ipv4-familyvpn-instancecommand for BGP/MPLS VPN. For related description, refer to "MPLS
VPN" chapter in module "MPLS" module of this manual.
ipv4-family
Use the ipv4-family multicast command to enter MBGP multicast address family view.
Use the ipv4-familyvpn-instancecommand to enter MBGP vpn-instance address family view.
Use the ipv4-family vpnv4 command to enter MBGP VPNv4 address family view.
ipv4-family multicast
Use the ipv4-family multicast command to enter the IPv4 multicast subaddress family view.
BGP view
ipv4-familyvpn-instance
Use the ipv4-familycommand to enter MBGP address family view of RIP.
ipv4-family vpnv4
Use the ipv4-family vpnv4 command to enter VPNv4 address family view of BGP.
BGP view
idle-mark
Use the idle-markcommand to configure the idle coding scheme of the synchronous serial port.
ipx enable
Use the ipx enable command to activate IPX.
ipx encapsulation
Use the ipx encapsulation command to set IPX frame encapsulation format on Ethernet interface.
