3Com manual 43Com Router 5000/6000 Family Command Reference

43Com Router 5000/6000 Family Command Reference

address

Use the address command to configure a route to the peer voice gateway or assign an X.121 address for a destination host.

Voice Entity view

address sip

Use the address sip command to set routing policy for reaching the remote voice gateway (VG) to SIP.

Voice Entity view

adsl standard

Use the adsl standard command to set the standard applied to the ADSL interface.

ATM (ADSL) Interface view

adsl tx_attenuation

Use the adsl tx_attenuation command to set attenuation value for ADSL transmit power.

ATM (ADSL) Interface view

adv-factor

Use the adv-factorcommand to configure the advantage factor which is used to count Mos and ICPIF value in a jitter voice test.

HWPing Test Group view

aggregate

Use the aggregate command to establish an aggregated record in the BGP routing table.

BGP view

aggregate

Use the aggregate command to create a multicast aggregated record in the BGP routing table.

Use the aggregate command without parameters to create one local aggregated route and set atomic aggregation attributes.

IPv4 Multicast Subaddress Family view

aging-time

Use the aging-timecommand to configure SYN status waiting timeout value and FIN status waiting timeout value of TCP, session entry idle timeout value of TCP and UDP.

ASPF Policy view

ah authentication-algorithm

Use the ah authentication-algorithmcommand to set the authentication algorithm adopted by

Authentication Header protocol in IPSec proposal.

Use the undo ah authentication-algorithmcommand to restore the default setting.

IPSec Proposal view

ahdsl annex

Use the shdsl annex command to configure annex standard at an SHDSL interface. You cannot activate a link with different standard types at its two ends.

ATM (G.SHDSL) Interface view

alarm (CT3 Interface)

Use the alarm command to enable the CT3 interface to detect/send alarm signals.

CT3 Interface view

alarm-threshold

Use the alarm-thresholdcommand to configure the alarm thresholds on the CT1/PRI interface as needed.

CT1/PRI Interface view

algorithm-suite

Use the algorithm-suitecommand to specify the algorithm suite used when a client registers.

Dvpn-Class view

allow l2tp

Use the allow l2tp command to specify the name of the peer end of the tunnel on receiving call and the

Virtual-Template it uses.

L2TP Group view

annexg

Use the annexg command to enable T1.617 Annext G on the frame relay interface for data transmission.

DLCI view

ani

Use the ani command to enable or disable the terminating point to send the calling party information (service category and calling number) to the originating point during call connecting process.

R2 CAS view