623Com Router 5000/6000 Family Command Reference
display x25 x2t switch-table
Use the display x25 x2t switch-tablecommand to display the dynamic switching routing table and static routing table.
display x25 xot
Use the display x25 xot command to view XOT link information.
dl-bits
Use the dl-bitscommand to configure the bit value of all the signals of R2 line signaling.
dlsw bridge-set
Use the dlsw bridge-setcommand to configure the bridge group to connect DLSw. Use the undo dlsw bridge-setcommand to delete the bridge.
dlsw enable
Use the dlsw enable command to enable DLSw performance.
dlsw ethernet-backup enable
Use the dlsw ethernet-backup enable command to enable DLSw Ethernet redundancy.
dlsw ethernet-backup map
Use the dlsw ethernet-backup map command to enable the Ethernet switch support feature for DLSw Ethernet redundancy, that is, to map the MAC address of a remote SNA device to a local virtual MAC address.
dlsw ethernet-backup timer
Use the dlsw ethernet-backup timer command to configure the time for which the master DLSw router waits before sending a positive or negative response to the slave DLSw router upon receipt of a circuit establishing request.
dlsw ethernet-frame-filter
Use the dlsw ethernet-frame-filtercommand to apply an ACL in the transmitting and receiving directions of DLSW module towards bridge module so that it can transmit and receive only the Ethernet frames with permitted source MAC addresses.
dlsw filter acl
Use the dlsw filter acl command to specify to filter packets from any peer.
dlsw local
Use the dlsw local command to create the DLSw local peer.
dlsw max-transmission
Use the dlsw max-transmissioncommand to set the maximum number of the attempts to send an explorer frame.
dlsw multicast
Use the dlsw multicast command to enable the multicast function of DLSw2.0.
dlsw reachable
Use the dlsw reachable command to configure locally reachable MAC and SAP addresses.
dlsw reachable-cache
Use the dlsw reachable-cachecommand to add the reachability information of the specified SNA device to the reachable-cache. You can specify this SNA device by specifying its MAC address and IP address of the router to which it is connected.
dlsw remote
Use the dlsw remote command to create the DLSw remote peer.
