6

3Com Router 5000/6000 Family

 

Command Reference

apply origin

Use the apply origin command to set the routing source of BGP routing information.

Routing Policy view

apply output-interface (for Multicast Policy Routing)

Use the apply output-interfacecommand to configure an outgoing interface list in a route-node.

Route-Policy view

apply output-interface (for Unicast Policy Routing)

Use the apply output-interfacecommand to set a packet forwarding interface.

Route-Policy view

apply policy outbound

Use the apply policy outbound command to set the frame relay virtual circuit queuing to CBQ (Class-Based Queuing).

Frame Relay Class view

apply tag

Use the apply tag command to set the tag area of OSPF route information.

Routing Policy view

area

Use the area command to enter OSPF area view.

OSPF view

OSPF Area view

area

Use the area command to configure the type of busy tone detection for FXO voice subscriber-line.

Voice Subscriber-line view

area-authentication-mode

Use the area-authentication-modecommand to configure IS-IS to authenticate the received Level-1 routing information packets (LSP, CSNP and PSNP), according to the pre-defined mode and password.

IS-IS view

area-id (Voice Entity view)

Use the area-idcommand to configure the area ID of voice GW.

Voice Entity view

area-id (Voice GK Client view)

Use the area-idcommand to configure the H.323 gateway area ID.

Voice GK Client view

arp check enable

Use the arp check enable command to enable ARP entry check to have the device not learn the ARP entries with broadcast MAC addresses.

System view

arp-proxy enable

Use the arp-proxy enable command to enable proxy ARP on an interface.

Ethernet interface view

arp security

Use the arp security command to disable dynamic ARP learning on an Ethernet interface.

Ethernet Interface view

arp security time-out

Use the arp security time-outcommand to configure the aging time of the authorized ARP entries.

Ethernet Interface view

arp send-gratuitous-arp

Use the arp send-gratuitous-arpcommand to enable sending gratuitous ARP packet on this interface periodically and set the sending period.

Bridge Template view

Ethernet Interface view

Ethernet Subinterface view

Gigabit Ethernet Interface view

Gigabit Ethernet Subinterface view

Virtual Ethernet interface view

VLAN Interface view

arp static

Use the arp static command to configure ARP mapping table.

System view

Page 6
Image 6
3Com 5000/6000 manual Frame Relay Class view, Ospf view Ospf Area view, Voice Subscriber-line view, IS-IS view