3Com Router 5000/6000 Family | 149 |
Command Reference |
|
timeout
Use the timeout command to configure a timeout time for a test.
HWPing Test Group view
timer (Digital E&M)
Use the timer command to configure the timeout values of the signals in the digital E&M signaling.
Digital E&M Voice Subscriber-Line view
timer configuration
Use the timer configuration command to set the interval to send ISH packets.
ES-IS view
Use the timer
Voice Subscriber-Line view
timer dl (R2)
Use the timer dl command to configure the timeout value of line signals of R2 signaling.
R2 CAS view
timer dtmf (R2)
Use the timer dtmf command to configure the time interval for sending DTMF signals.
R2 CAS view
timer
Use the timer
Voice Subscriber-Line view
timer hold
Use the timer hold command to set the polling interval.
Interface view
timer hold
Use the timer hold command to configure the polling timer at the DTE side.
Interface view
timer hold
Use the timer hold command to set the timer to send keepalive packet.
Serial Interface view
timer holding
Use the timer holding command to set the holding time of the information ISH packets sent carry.
timer
Use the timer
BGP Unicast view
BGP Multicast view
VPNv4 view
VPN Instance view
timer loop
Use the timer loop command to set the auto detect interval, that is, the frequency for auto detect.
Detect Group view
timer
Use the timer
IS-IS view
Use the timer
IS-IS view
timer quiet
Use the timer quiet command to set the duration that the primary server must wait before it can resume the active state.
RADIUS view
timer quiet
Use the timer quiet command to set the duration that a primary server must wait before it can resume the active state.
