3Com 5000/6000 manual BGP Unicast view, R2 CAS view

3Com Router 5000/6000 Family	69
Command Reference
filter-policy import
Use the filter-policy gateway import command to filter the learned routing information advertised by
the specified address.
Use the filter-policy import command to filter the received global routing information.	BGP Unicast view
	BGP Multicast view
	VPNv4 view
	VPN Instance view
filter-policy import
Use the filter-policy import command to configure to filter the routes received by IS-IS.	IS-IS view
filter-policy import
Use the filter-policy import command to configure the OSPF rules of filtering the routing information
received.
Use the filter-policy import command to filter the routes calculated by OSPF. Only the filtered routes
can be added to the routing table. The filtering can be performed according to the next hop and destination
of the route.	OSPF view
filter-policy import
Use the filter-policy gateway command to configure to filter the received routing information distributed
from the specified address.
Use the filter-policy import command to configure the filtering to the received global routing
information.	RIP view
final-callednum
Use the final-callednumcommand to enable or disable the terminate signal to be sent to the terminating
point after the called number is sent.	R2 CAS view
firewall aspf
Use the firewall aspf command to apply ASPF policy in specified direction to an interface.	Interface view
firewall default
Use the firewall default command to configure the default filtering rule of the firewall, whether to be
“permit” or “deny”.	System view
firewall enable
Use the firewall enable command to enable the firewall.	System view
firewall ethernet-frame-filter
Use the firewall ethernet-frame-filtercommand to apply a MAC-based ACL on the interface.	Interface view
firewall fragments-inspect
Use the firewall fragments-inspectcommand to enable fragment inspection switch.	System view
firewall fragments-inspect {high low}
Use the firewall fragments-inspect { high low } command to configure the high and low thresholds
of records for fragment inspection.	System view

firewall packet-filter

Use the firewall packet-filtercommand to apply the access control list to the corresponding interface.

Interface view

first-rule

Use the first-rulecommand to configure the number-substitute rule that is first used in the current number-substitute list.

Voice Number-Substitute view

fixdisk

Use the fixdisk command to restore the space of a storage device when it becomes unavailable because of some abnormal operation.

User view