1403Com Router 5000/6000 Family Command Reference
snmp-agenttarget-host
Use the snmp-agenttarget-hostcommand to set the destination that receives SNMP notifications.
Use the snmp-agenttarget-hostcommand in conjunction with the snmp-agent trap enable command.
snmp-agent trap enable
Use the snmp-agent trap enable command to enable the device to send traps and set the trap and notification parameters.
snmp-agent trap enable encrypt-card
Use the snmp-agent trap enable encrypt-cardcommand to enable SNMP agent trap function on the encryption card.
snmp-agent trap enable ldp
Use the snmp-agent trap enable ldp command to enable Trap function in MPLS LDP creation.
snmp-agent trap enable lsp
Use the snmp-agent trap enable lsp command to enable Trap function in MPLS LSP creation.
snmp-agent trap enable mobile-ip
Use the snmp-agent trap enable mobile-ipcommand to enable the MIP SNMP trap function. With the function enabled, a trap packet is sent to the network management software whenever a security violation event occurs.
snmp-agent trap enable ospf
Use the snmp-agent trap enable ospf command to enable the TRAP function of OSPF.
snmp-agent trap life
Use the snmp-agent trap life command to set the lifetime of traps. The expired traps are discarded without being retained or sent.
snmp-agent trap queue-size
Use the snmp-agent trap queue-sizecommand to set the length of the trap queue to the specified host.
snmp-agent trap source
Use the snmp-agent trap source command to specify the source address of traps.
snmp-agentusm-user
Use the snmp-agentusm-usercommand to add a new user to an SNMP group.
sot counter keepalive
Use the sot counter keepalive command to specify the number of keepalive checks before disconnecting from the peer SOT entity.
sot gather
Use the sot gather command to assign the serial interface to an existing SOT protocol group.
sot group-set
Use the sot group-setcommand to set up a SOT protocol group.
sot peer
Use the sot peer command to assign an IP address to the local SOT entity.
sot sdlc broadcast
Use the sot sdlc broadcast command to configure the broadcast address FF for the connected SDLC terminals, allowing them to receive broadcast frames.
sot sdlc controller
Use the sot sdlc controller command to configure the SDLC address of a connected terminal.