
3Com Router 5000/6000 Family | 143 |
Command Reference |
|
ssh user
Use the ssh user
System View
ssh2
Use the ssh2 command to initiate a connection to the specified SSH server, and specify the preferred key exchange algorithm, encryption algorithm and HMAC algorithm between the client and the server.
System view
ssh2
Use the ssh2
System view
ssh2
Use the ssh2
This IP address must be a local IP address.
System view
standby bandwidth
Use the standby bandwidth command to configure the actual bandwidth that the main interface uses in backup load sharing.
Interface view
standby
Use the standby
Interface view
standby interface
Use the standby interface command to specify a physical interface to back up the interface.
Interface view
standby
Use the standby
Dial Interface view
standby
Use the standby
System view
standby threshold
Use the standby threshold command to configure backup load sharing on an interface or logical channel.
Interface view
standby timer delay
Use the standby timer delay command to set failover and fallback delays on the interface, avoiding frequent switchover caused by instability of interface state.
Interface view
standby timer
Use the standby timer
Interface view
standby timer
Use the standby timer
Dial Interface view
start l2tp
Use the start l2tp command to specify conditions triggering the local end to place calls when it works as
L2TP LAC.
L2TP Group view
start l2tp tunnel
Use the start l2tp tunnel command to enable the L2TP LAC to start L2TP tunnel connection.
L2TP Group view
start script
Use the