
14 | 3Com Router 5000/6000 Family |
| Command Reference |
|
|
cid enable |
|
| Use the cid enable command to enable CID on the FXO interface. |
| Voice |
|
|
cid |
|
| Use the cid |
| up VoFR calls. |
| DLCI view |
|
|
cid send |
|
| Use the cid send command to enable the FXO or FXS module to send calling numbers to the IP side. |
| Voice |
|
|
cid type |
|
| Use the cid type command to configure the format of transmitted information about the calling party. |
| Voice |
|
|
cir |
|
| Use the cir command to set the CIR of frame relay virtual circuit. |
| Frame Relay Class view |
|
|
cir allow |
|
| Use the cir allow command to set the CIR ALLOW of frame relay virtual circuit. |
Frame Relay Class view
classifier behavior
Use the classifier behavior command to specify the behavior for the class in the policy.
Policy view
Use the
R2 CAS view
clns enable
Use the clns enable command to enable CLNS.
System view
clns erpacket enable
Use the clns erpacket enable command to enable generation of error report packets.
System view
clns erpacket interval
Use the clns erpacket interval command to set the minimum interval to generate two successive error report packets.
System view
clns
Use the clns
System view
clns net
Use the clns net command to assign an NET address to the IS.
System view
clns rdpacket enable
Use the clns rdpacket enable command to enable the router to send RD packets.
System view
clns rdpacket interval
Use the clns rdpacket interval command to set the minimum interval to generate RD packets.
System view
clns
Use the clns
System view
clns timer rdpacket holding
Use the clns timer rdpacket holding command to set the holding time of the information a RD packet carries.
System view
clock
Use the clock command to set the clock mode of the ATM E1/T1 interface.