3Com 3Com Router 5000/6000 Family 159 Command Reference, Synchronous Serial Interface view

3Com Router 5000/6000 Family		159
Command Reference
x25	ignore called-address
	Use the x25 ignore called-addresscommand to enable it to ignore the X.121 address of the called DTE
	when X.25 initiates calls.	Interface view
x25	ignore calling-address
	Use the x25 ignore calling-addresscommand to enable it to ignore the X.121 address of the calling
	DTE when X.25 initiates calls.	Interface view
x25	local-cug
	Use the x25 local-cugcommand to configure mapping from local CUG to network CUG and define its
	suppression rule.	Interface view
x25	map
	Use the x25 map command to set the address mapping between IP address used by LANs and X.121
	address.	Interface view
x25	map bridge
	Use the x25 map bridge command to map an X.121 address to a bridge-set.	Interface view
x25	map clns
	Use the x25 map clns command to configure a CLNS address mapping for an X.121 address.	Interface view
x25	modulo
	Use the x25 modulo command to set the window modulus of an X.25 interface.	Interface view
x25	packet-size
	Use the x25 packet-sizecommand to set the maximum input and output packet lengths of X.25 interface.	Interface view
x25	pvc
	Use the x25 pvc command to configure one PVC route encapsulated with datagram.	Interface view
x25	pvc
	Use the x25 pvc command to configure an X.25 PVC route.	Interface view
x25	qllc-switch
	Use the X25 qllc-switchcommand to create a QLLC switching map entry, an association of X.121
	address, MAC address of the SNA device, and local virtual MAC address.
	Synchronous Serial Interface view
x25	queue-length
	Use the x25 queue-lengthcommand to set the data queue length on X.25 VC.	Interface view
x25	receive-threshold
	Use the x25 receive-thresholdcommand to set the number of receivable maximum packets before X.25
	sends the acknowledged packet.	Interface view
x25	response called-address
	Use the x25 response called-addresscommand to enable X.25 to carry the address information of the
	called DTE in sending call reception packet.	Interface view
x25	response calling-address
	Use the x25 response calling-addresscommand to enable X.25 to carry the address information of the
	calling DTE in sending call reception packet.	Interface view
x25	reverse-charge-accept
	Use the x25 reverse-charge-acceptcommand to enable this interface to accept the call with “reverse

charging request”, the information added by some certain user facilities.

Interface view