Agilent Technologies 87020 Agilent 8702D Option 011 and Agilent 85046A/ 47A System Verification

5-4

Automated Verification – Option 011

Agilent8702D Option 011 and Agilent 85046A/47A System Verification

Agilent 8702D Option 011 and Agilent 85046A/47A System Verification

In order to run this procedure, the following equipment is required:

S-Parameter test set (for analyzers without Option 006) . . . .Agilent 85046A

S-Parameter test set (for analyzers with Option 006) . . . . . . .Agilent 85047A

Calibration Kit, 7 mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Agilent 85031B

Verification Kit, 7 mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Agilent 85029B

RF Cable Set, 7 mm, 50Ω. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Agilent 11857D

Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HP ThinkJet/DeskJet/LaserJet

Step 1. Initialization

1Connect the equipment as shown in Figure 5-1. Let the Ag ilent 8702D

Option 011 warm up for one hour.

NOTE

Do not proceed any further if your system has an Agilent 85044A Transmission/Reflec-

tion test set. Instead, go to “Agilent8702D Option 011 and Agilent 85044A System Veri-

fication” on page5-13.