1-13
Installing the Agilent 8702D
Step 9. If You Connect a Printer
Step 9. If You Connect a Printer
1Press LOCAL, SET ADDRESSES, PRINTER PORT.
2Press the key that corresponds to the printer interface: HPIB, PARALLE L (parallel
port), or SERIAL (serial port).
3If you selected HPIB, the GPIB address is active so you can then set the address
of your printer. The default GPIB printer address is 1.
4If you select SERIAL, adjust the Agilent8702D’s baud rate and handshaking
protocol:
aPress PRINTER BAUD RATE, and use the up and down arrow front-panel keys to
select the baud rate.
bSet the transmission control, XMIT CNTRL (handshaking protocol) to either
XON/XOFF or DTR/DSR (equal to the transmission control set on the peripher-
al).
XON/XOFF selects software handshaking. DTR/DSR selects hardware
handshaking. Consult the printer’s manual for the proper settings.
5Press PRNTR TYPE until the correct printer choice appears:
•ThinkJet (QuietJet)
•DeskJet (except for HP1 DeskJet 540)
• LaserJet
• PaintJet
•Epson-P2 (printers that conform to the ESC.P2 printer control language)
•DJ540 (converts 100 dpi raster information to 300 dpi raster format)
1. HP is a registered trademark of Hewl ett-Packard Company.