1-12
Installing the Agilent 8702D
Step 8. Connect a Printer or Plotter
Step 8. Connect a Printer or Plotter
1Connect a printer or plotter to the corresponding interface port. Refer to
Figure 1-6 on page 1-10 for the appropriate rear panel connection.
2If you are using the parallel interface, press LOCAL and then PARALLEL until COPY
appears.
The GPIO selection dedicates the parallel port for general purpose I/O. The
Agilent8702D controls the data input or output through the sequencing capa-
bility of the instrument.
3If you are using an GPIB printer or plotter, press LOCAL, SYSTEM CONTROLLER to
set up the Agilent8702D as the controller.
Printer Interface Recommended Cable
Parallel Agilent 92284A
Serial Agilent 24542G
GPIB Agilent 10833A/B/D