Bosch Appliances 3.5 manual 8.7Configuration and operation, 8.7.1Introduction, 8.7.2Start-up, Idle

Models: 3.5

1 498
Download 498 pages 15.1 Kb
Page 149
Image 149
8.7Configuration and operation

Praesideo 3.5 Installation and User Instructions 4 Amplifiers

en 149

8.7Configuration and operation

8.7.1Introduction

The next sections give descriptions of the possible configuration options. Each description is followed by the relevant menu items with detailed instructions per menu option. The default values are indicated by an asterisk (*) when applicable.

8.7.2Start-up

When the power amplifier is (re)started, the display shows the name of the unit and the VU meters for the outputs. If it shows Load Unit Software, the unit does not contain any firmware or old firmware. By default, it is delivered without firmware. See section 36.5 for information about upgrading the firmware.

8.7.3Status screen

The Status screen (see figure 8.18) shows the name of the power amplifier and provides general information about its (fault) status (see table 8.7). If there is more than one active fault, only the most severe fault is shown. A fault status only provides global information. The exact source of a fault can be found out using the fault events list in this manual (see chapter 54).

table 8.7: Status (in order of severity: high to low)

Fault status

Description

No network

The optical network is not

 

available.

Fault: Channel n

Fault in amplifier channel n.

 

(If n = +, faults in multiple

 

amplifier channels.)

Fault: Line Ch n

Fault in loudspeaker line n.

 

(If n = +, faults in multiple

 

loudspeaker lines.)

Fault: Lsp Ch n

Fault in a loudspeaker in line n.

 

(If n = +, loudspeakers on

 

multiple lines are failing).

Fault: Input CIn

Fault in control input n.

 

(If n = +, faults in multiple control

 

inputs.)

 

 

Fault: Input AIn

Fault in audio input n.

 

(If n = +, faults in multiple audio

 

inputs.)

Fault: Mains

Mains power supply failure.

Fault: Battery

Back-up power supply failure.

Idle

Spare power amplifier that is not

 

sparing at the moment.

 

 

Standby

Standby mode or disabled in

 

system configuration.

VU meters

Fully operational.

Bosch Security Systems 2011-02

Page 149
Image 149
Bosch Appliances 3.5 8.7Configuration and operation, 8.7.1Introduction, 8.7.2Start-up, 8.7.3Status screen, Fault: Lsp Ch n