Bosch Appliances 3.5 36.5Upgrade firmware, 6: Praesideo web interface home page, 7: Logon window

Praesideo 3.5 Installation and User Instructions 8 Software

en 314

36.5Upgrade firmware

After the system files have been transferred to the network controller (see section 36.4), the firmware files must be installed on all units, including the network controller. Installing new firmware will generate a fault event (Unit Missing), since the units are temporarily ‘removed’ from the network. This fault is automatically resolved and can be acknowledged and reset.

Note

All units must run the same firmware release. Do not use the system or switch units on or off while upgrading the firmware.

Proceed as follows:

1 On the configuration PC, start the web browser program.

2Enter the IP address of the network controller in the address bar. Do not use leading zeros in the IP address. For example, if the IP address that is displayed on the network controller is 192.168.000.015, enter 192.168.0.15 in the address bar. A screen similar to the one in figure 36.6 appears.

figure 36.6: Praesideo web interface home page.

Note

If the network controller and PC are connected to an existing Ethernet, which uses a proxy for normal Internet traffic, it is possible that the network controller cannot be reached. In that case, disable the proxy server in Windows LAN settings or add the name of the network controller to the hosts file in the Windows system directory and use this name for the connection.

3Select a language for the web interface at the bottom of the page.

4Click the Continue button to access the web interface. A screen similar to the one in figure 36.7 pops up.

figure 36.7: Logon window

5Enter the user name in the User Name field and the password in the Password field and click OK to open the web interface. A screen similar to the one in figure 36.8 appears.

Note

The default user name is admin, the default

password is admin.

Bosch Security Systems 2011-02