Bosch Appliances 3.5 manual 43.6Fiber interface, 43.7CobraNet interface, Procedure, Control inputs

Praesideo 3.5 Installation and User Instructions 9 System Configuration

en 361

43.6Fiber interface

43.6.1 Procedure

Proceed as follows to configure a fiber interface:

1Go to Configure > Equipment configuration > Fiber interface. A screen similar to the one in figure 43.31 appears in the main frame of the web interface.

figure 43.31: Configure fiber interface step 1

2Click the name of the fiber interface that must be configured. A screen similar the one in figure 43.32 appears in the main frame of the web interface.

figure 43.32: Configure fiber interface, step 2

3Configure the control inputs of the fiber interface (see section 43.6.2).

4Submit the changes. Note that the changes are not permanent until the configuration is saved (see section 40.4.4 and 40.4.5).

43.6.2 Control inputs

The configuration page for fiber interface control inputs is similar to the configuration page for network controller control inputs (see section 43.2.5).

43.7CobraNet interface

Proceed as follows to configure a CobraNet interface:

1Go to Configure > Equipment configuration > CobraNet interface. A screen similar to the one in figure 43.33 appears in the main frame of the web interface.

figure 43.33: Configure CobraNet interface step 1

2Click the name of the CobraNet interface that must be configured. A screen similar to the one in figure 43.34 appears in the main frame of the web interface.

figure 43.34: Configure CobraNet interface step 2

3Open the Audio inputs category to configure the audio inputs of the CobraNet interface (see

section 43.7.1).

4Open the Audio outputs category to configure the audio outputs of the CobraNet interface (see

section 43.7.2).

5Open the Control inputs category to configure the control inputs of the CobraNet interface (see section 43.7.3).

Bosch Security Systems 2011-02