Bosch Appliances 3.5 manual Processor reset, Redundant ring broken

Praesideo 3.5 Installation and User Instructions 10 Events

en 430

Event message:

Processor reset

Originator:

Unit in which the fault occurred. Extra information:

The type of processor that caused the reset. This fault event aggregates to a System fault.

Description:

Logs the watchdog reset of a processor.

This fault event can only be generated by units that are started up. It cannot be generated by open interface clients.

Resolve:

Immediately after acknowledgement.

Recommended action:

•In case this fault occurs for all connected units when performing the action Save the configuration and restart the system, this is probably caused by using a network controller with HW version 20.00 or older in combination with Praesideo release 3.4 or later. See the Note in section 40.4.5. Just acknowledge and reset these faults.

•Check for network faults. For example, units that are reported to be missing or using the half power mode (see section 50.4). Critical network connections can be found by using the half power mode in Diagnose\Installation

•Make sure that all units contain the correct firmware.

•Check for faults that tell you that the configuration file is corrupt (for example, Configuration file error or Configuration file version mismatch).

Especially check for missing audio equalizer settings that show up as question marks; then create a new configuration file.

•Check for faults that tell you that the flash card is corrupt.

•Then switch the unit off and on again or disconnect and reconnect the unit.

Event message:

Redundant ring broken

Originator:

----

Extra information:

----

Description:

Logs a break in the redundant ring. Resolve:

When the redundant ring is restored. Recommended action:

•Restore the redundant ring OR

•On the System wide settings pages of the configuration software, set Redundant ring network to No.

Bosch Security Systems 2011-02