Bosch Appliances 3.5 manual Crimping bush, Stripping copper wires, 8 Cross-sectiontransformation

Praesideo 3.5 Installation and User Instructions 6 Installation Accessories

en 283

29.4.4 Crimping bush

Proceed as follows:

6Slide the crimping bush over the cable and position it at the end of the outer sheath.

Note

In the next step, the circular shape of the cable cross-section at the end of the outer sheath is transformed into a hexagonal shape using the crimping tool (tool 3) and the crimping bush. Before crimping the bush, ensure that both plastic optical fibers will be positioned parallel to a flat side of the hexagonal cross-section (see figure 29.8)

7Crimp the bush on the outer sheath using the crimping tool (tool 3, see figure 29.9). The crimping bush will prevent the cable from rotating in the connector.

R	B	B
		R
	A	B
B	R	R = Red
		B = Brown
	A

figure 29.8: Cross-section transformation

figure 29.9: Crimping the bush

29.4.5 Stripping copper wires

Proceed as follows:

8Cut the copper wires at the required length using the cable cutter (tool 2) and the stripping tool (tool 5). To this end, position the crimping bush in position I and cut the copper wires at position II (see figure 29.10).

I

II

figure 29.10: Cutting a copper wire

Bosch Security Systems 2011-02