Bosch Appliances 3.5 Assembling the connector, 25: Crimping ferrules, 26: Ferrules on fibers

Praesideo 3.5 Installation and User Instructions 6 Installation Accessories

en 288

25Crimp the ferrules on the sheath using the crimping tool (tool 3, see figure 29.25). See figure 29.26 for the result of this part of the cable-connector mounting procedure.

29.4.9 Assembling the connector

Before starting to assemble the connector, position the copper wires and the plastic optical fibers for installation. The copper wires will be installed in the upper part of the connector, whereas the fibers will be installed in the lower part of the connector (see figure 29.27).

Note

When replacing a connector, always first check the wiring in the connector at the other end.

figure 29.25: Crimping ferrules (3)

AB

figure 29.26: Ferrules on fibers

E1 E2

O1 O2

figure 29.27: Front view of connector

table 29.3: Optical network connector details

Pin	Signal	Wire
E1	+48V(DC)	Copper
E2	GND	Copper
O1	Data	Optical fiber
O2	Data	Optical fiber

Also, observe the wiring diagram (see figure 29.28). For the practical implications of this diagram, see

figure 29.29 and figure 29.30).

E1	RED	E1
	BROWN
E2		E2
O1		O1
O2		O2
	BLACK (2x)

figure 29.28: Wiring diagram

Bosch Security Systems 2011-02