Bosch Appliances 3.5 manual Stripping fibers, 14: Crimping a socket contact, 16: Cutting a fiber

Praesideo 3.5 Installation and User Instructions 6 Installation Accessories

en 285

11Slide one of the stripped, copper wires into the contact area of the socket contact and close the crimping tool to crimp the socket contact onto the copper wire (see figure 29.14).

29.4.7 Stripping fibers

Proceed as follows:

13Slide the plastic optical fibers into the

POF cutter/stripping tool (tool 6). The fiber that is going to be cut-off must be put in the small guiding hole, whereas the other fiber must be put in the large guiding hole (see figure 29.16). The crimping bush must rest against the stop (see figure 29.17).

figure 29.14: Crimping a socket contact (2)

12Repeat steps 10 and 11 for the other stripped, copper wire. See figure 29.15 for the result of this part of the cable-connector installation procedure.

AB

figure 29.15: Installed socket contacts

figure 29.16: Cutting a fiber (1)

figure 29.17: Cutting a fiber (2)

Bosch Security Systems 2011-02