Bosch Appliances 43.3.5Line and loudspeaker supervision, 14: Add supervision device, step, en

Praesideo 3.5 Installation and User Instructions 9 System Configuration

en 350

43.3.5Line and loudspeaker supervision

43.3.5.1 Adding supervision devices

Proceed as follows to add a supervision device to an audio output of a power amplifier:

1Click the Configure supervision devices button in the Audio Outputs category of the applicable power amplifier (see section 43.3.4). A screen similar to the one figure 43.14 appears.

3Enter the data of the supervision device (see figure 43.16 for an example).

•Enter a name for the supervision device in the Name field. The name may consist of up to 16 characters.

•Select the type of supervision device from the Type dropdown list.

Note

When you want to use an LBB4441 (PRS-SVLSP) to supervise the loudspeaker line as well, it is recommended that you install the LBB4441 in the last loudspeaker in the line. To enable loudspeaker line supervision, put a check mark in the Line box. The LBB4441 will then be polled more often.

•Enter the address that was assigned to the supervision device in the Address field (see figure 43.16).

figure 43.14: Add supervision device, step 1

2Click the Add button to add a new supervision device to the audio output. A screen similar to the one in figure 43.15 appears.

figure 43.15: Add supervision device, step 2

Note

It is also possible to add multiple supervision devices of the same type at the same time by entering an address range in the Address field, e.g. 1-6.

figure 43.16: Add supervision device, step 3

Bosch Security Systems 2011-02