Epson S1D13504 5.5 S1D13504 Configuration

Page 20 Epson Research and Development
Vancouver Design Center
S1D13504 Interfacing to the Philips MIPS PR31500/PR31700 Processor
X19A-G-005-08 Issue Date: 01/02/02
5.5 S1D13504 Configuration
The S1D13504 latches MD15 through MD0 to allow selection of the bus mode and other
configuration data on the rising edge of RESET#. For details on configuration, re fer t o the
S1D13504 Hardware Specification, document number X19A-A-002-xx.
The partial table below only shows those configuration settings relevant to the IT8368E
implementation.
Table 5-3: S1D13504 Configuration using the IT8368E
S1D13504
Pin Name
value on this pin at rising edge of RESET# is used to configure:(1/0)
10
MD0 8-bit host bus interface 16-bit host bus interface
MD1
See “Host Bus Selection” table below See “Host Bus Selection” table belowMD2
MD3
MD4 Little Endian Big Endian
MD5 WAIT# signal is active high WAIT# signal is active low
= required configuration for connection using ITE IT8368E
Table 5-4: S1D13504 Host Bus Selection using the IT8368E
MD3 MD2 MD1 Host Bus Interface
0 0 0 SH-3 bus interface
0 0 1 MC68K bus 1 interface (e.g. MC68000)
0 1 0 MC68K bus 2 interface (e.g. MC68030)
0 1 1 Generic bus interface (e.g. MCF5307, ISA bus interface)
1 x x Reserved
= required configuration for connection using ITE IT8368E