EQQG005E EQQG010I
EQQG005E VALIDATION FAILED FOR FILE:
FILE
, REASON:
REASON
, OFFSET:
POS
Explanation: The record that was to be written to the TME 10 OPC database was rejected because it was incorrect.
System action: No update to the database is made.
Problem determination:
FILE
gives the database on which the update was attempted;
REASON
indicates the
reason for the failure; and
POS
indicates the failing position in hexadecimal form within the record.
See Chapter 36, “Reason Codes” on page 481 for a list of the reason codes and their meanings.
User response: Look in the dump dataset (with ddname EQQDUMP) for further information about the error. This
dataset contains the record and the position of the error. If you cannot find a valid reason for the error, contact your
system programmer.
System programmer response: If you cannot find a valid reason for the error, make the dump dataset (with
ddname EQQDUMP) and the message log available for inspection. Contact your IBM representative.
EQQG006I THE
FUNC
FUNCTION IS
ACTION
by
USER
Explanation: This message confirms and logs some action taken to an TME 10 OPC function.
FUNC
is either
AUTOMATIC JOB RECOVERY or JOB SUBMISSION.
ACTION
is either ACTIVATED or DEACTIVATED.
USER
is
the userid of the user who requested the function. The message confirms that the dialog request has been
successfully accomplished.
System action: Processing continues.
User response: None.
EQQG008W THE REQUEST FAILED, GENERAL SERVICE QUEUING PROBLEM, REASON:
XSSRS
Explanation: The request was rejected because of an interface problem in the General Service function.
System action: The system waits for you to respond.
Problem determination: Review the TME 10 OPC message log for errors related to General Service to determine
the cause of the error.
User response: Try again. If the error persists, contact your system programmer.
System programmer response: Correct the General Service error given in the TME 10 OPC message log.
EQQG009W INSUFFICIENT VIRTUAL STORAGE FOR THE COMPLETE LIST, REASON:
XSSRS
Explanation: The requested list could not be displayed because the amount of virtual storage in the dialog address
space was not sufficient.
System action: A partial list is displayed, or no list at all.
User response: If this is a request from a dialog function in which a selection criterion can be specified, change the
selection criterion to select fewer items. Increase the region size at TSO logon.
EQQG010I GENERAL SERVICE REQUEST STATISTICS FOLLOW:
TYPE TOTAL NEWRQS TOTTIME NEWTIME TOTAVG NEWAVG
|Explanation: This message is issued if the GENERAL SERVICE task statistics are active. This can be done either
|by specifying the STATMSG(GENSERV) keyword in the JTOPTS initialization statement, or with the modify command,
|/F
subsys
,GENSTA=ON.
|This message is issued every
n
minutes if any requests have been processed, where
n
is the value specified in the
|JTOPTS keyword STATIM if it has a nonzero value, or the default of 30.
|It consists of column headers defining the values of the EQQG011I message following.
The following column headers are defined:
TYPE The request for which data was gathered.
TOTAL The total number of requests of this type.
NEWRQS The number of requests of this type since the last message.
106 TME 10 OPC Messages and Codes