EQQN102W EQQN108E
EQQN102W AN OPC/ESA USER EXIT LOAD MODULE,
MODULE
, COULD NOT BE LOADED
Explanation: TME 10 OPC could not locate an exit load module.
System action: This exit will not be used by TME 10 OPC.
Problem determination: Check if the module named in this message should be used by TME 10 OPC. Also check
that the module exists in a library that the subsystem started task can reach.
System programmer response: Correct the error, and restart the TME 10 OPC subsystem.
EQQN103E THE OPC/ESA EVENT HANDLER MODULE, EQQEMEVH, COULD NOT BE LOADED
Explanation: TME 10 OPC could not locate the event handler load module EQQEMEVH.
System action: TME 10 OPC initialization fails.
System programmer response: Make sure that the EQQEMEVH load module exists in a library that can be
reached by TME 10 OPC, then restart the TME 10 OPC started task.
EQQN105W NO VALID CURRENT PLAN EXISTS. CURRENT PLAN VSAM I/O IS NOT POSSIBLE
Explanation: The TME 10 OPC checkpoint dataset indicates that no valid current plan exists. All TME 10 OPC
functions that need access to the current plan dataset are inoperative.
System action: The NMM, which has been initialized, takes a new current plan if one is created by a daily plan
create batch job executing on behalf of this subsystem.
Problem determination: If this message was not expected, check that the started task procedure ddname
(EQQCKPT) is correctly specified. Also check that this subsystem is the only TME 10 OPC subsystem that
references this checkpoint dataset.
System programmer response: Correct the errors and, if necessary, restart the NMM.
EQQN106E ERRORS ENCOUNTERED PROCESSING NMM INITIALIZATION STATEMENTS. THE NORMAL
MODE MANAGER TASK WILL TERMINATE
Explanation: The Normal Mode Manager task found at least one error, while processing initialization statements.
System action: Normal Mode Manager initialization fails.
Problem determination: Review the previous messages in the message log dataset to determine the cause of the
problem.
System programmer response: Correct the error, and restart the TME 10 OPC subsystem.
EQQN107I THE NORMAL MODE MANAGER TASK HAS ENDED
Explanation: The Normal Mode Manager task is ending normally after having initialized successfully. Usually, this
message is due to an operator command requesting the TME 10 OPC subsystem to stop.
System action: Normal TME 10 OPC processing continues.
System programmer response: None.
EQQN108E THE NEW CURRENT PLAN DATA SET IS INVALID. A NEW NCP DATA SET MUST BE CREATED.
Explanation: The NMM task found that a new current plan in the NCP data set did not contain any header record.
System action: NMM will not use the contents of the NCP data set.
Problem determination: If a daily planing batch job has just ended check ending conditions for the job. If the error
occurs when TME 10 OPC is starting, verify that the DD statement defining the NCP file is correct, EQQNCPDS.
TME 10 OPC administrator response: Contact your system programmer.
System programmer response: If necessary, correct errors in the daily planning input data sets and rerun the daily
planning batch job, or, correct the NCP file definition problems and restart TME 10 OPC.
228 TME 10 OPC Messages and Codes