EQQX220E EQQX259E
EQQX220E THE INPUT ENTERED IS TOO LONG
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The longest value accepted is

HH.MM

, where:
HH The hour, in the range 00–24
MM The minute
EQQX226E HOUR PART OF DURATION MUST BE A NUMBER BETWEEN 0 AND 99
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQX227E OPERATION DURATION MUST BE GREATER THAN 00.00
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQX229E OPERATION
OP
DEADLINE EARLIER THAN OPERATION INPUT ARRIVAL
Explanation: The deadline must be the same as, or later than, the input arrival time.
System action: The request to write the record is rejected.
Problem determination: See the diagnostic file (EQQDUMP) for further information. This file contains a copy of the
record and the position of the error.
User response: Change the deadline or the input arrival time and resubmit the job. If the error persists, contact
your system programmer.
System programmer response: Review the TME 10 OPC message log to determine the cause of the error. If you
cannot determine the cause and the error persists, contact your IBM representative.
EQQX258E LOGICAL FILE HANDLER SUPPORT REQUIRED; TASK NOT ACTIVE
Explanation: The request has resulted in a request to the TME 10 OPC subsystem. The request cannot be handled
because the logical file handler is not available.
System action: The request is rejected.
User response: Contact your system programmer.
System programmer response: Review the TME 10 OPC message log and look for messages concerning the
logical file handler. Correct all errors and then restart the TME 10 OPC subsystem.
EQQX259E NORMAL MODE MANAGER SUPPORT REQUIRED; TASK NOT ACTIVE
Explanation: The request has resulted in a request to the TME 10 OPC subsystem. The request cannot be handled
because the Normal Mode Manager is not active.
System action: The request is rejected.
User response: Contact your system programmer.
System programmer response: Review the TME 10 OPC message log and look for messages concerning the
Normal Mode Manager. Correct all errors and then restart the TME 10 OPC subsystem.
Chapter 31. EQQXnnn Messages 339