EQQW406E EQQW503I
EQQW406E STARTED TASK OPTION INVALID OR NOT DEFINED
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The option can be Y (yes) or N (no).
EQQW407E WTO OPTION INVALID OR NOT DEFINED
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The option can be Y (yes) or N (no).
EQQW500E THE OPC/ESA JCL LIBRARY, DDNAME EQQJBLIB, COULD NOT BE OPENED
Explanation: TME 10 OPC could not open the JCL library (ddname EQQJBLIB) to read a member.
System action: If the failure occurred during job submission the operation extended status is set to error.
Problem determination: Review the preceding messages in the TME 10 OPC message log for a message
describing an error on the EQQJBLIB file.
User response: Contact your system programmer.
System programmer response: Check that the ddname EQQJBLIB is correctly specified and that the task started
by TME 10 OPC is authorized to open the dataset for input. When the error is corrected, stop TME 10 OPC and
then restart it.
EQQW501E LOGICAL RECORD SIZE FOR THE OPC/ESA JCL LIBRARY, DDNAME EQQJBLIB, IS INVALID
Explanation: TME 10 OPC could not read the JCL library (ddname EQQJBLIB) because the logical record length is
not 80 bytes.
System action: If the failure occurred during job submission the operation extended status is set to error.
Problem determination: Check the definition of the EQQJBLIB DD statement.
User response: Contact your system programmer.
System programmer response: Check that the ddname EQQJBLIB is correctly defined. When the error is
corrected, stop TME 10 OPC and then restart it.
EQQW502E WORK STATION ANALYZER INITIALIZATION FAILED
Explanation: The workstation analyzer could not acquire all the resources required for normal operation. The most
likely cause of this error is that the subsystem is being stopped but the Normal Mode Manager subtask has not
started. It is also possible that a submit/release dataset or the EQQJBLIB dataset could not be opened.
System action: If this message was issued while the TME 10 OPC subsystem was being stopped, subsystem
termination continues normally. Otherwise, message EQQZ045W is issued.
Problem determination: Review earlier messages in the TME 10 OPC message log to determine the exact cause
of the error.
System programmer response: Correct all errors and then restart the workstation analyzer.
EQQW503I THE WORK STATION ANALYZER ENDED NORMALLY
Explanation: This message is issued if the TME 10 OPC subsystem is being stopped and initialization of the
workstation analyzer has completed successfully. This message is also issued if a request has been made by an
operator modify command to stop the workstation analyzer.
System action: If this message was issued while the TME 10 OPC subsystem was being stopped, subsystem
termination continues normally. Otherwise message EQQZ045W is issued.
System programmer response: None.
314 TME 10 OPC Messages and Codes