EQQJ587W EQQJ598E
EQQJ587W VARIABLE
VAR
IN SAVEVAR DIRECTIVE NOT REFERRED IN JCL JOBNAME IS:
JNM
Explanation: During variable substitution of a job, a SAVEVAR directive was found requesting update of the default
value of a variable. This variable was however not referred to anywhere in the JCL.
System action: This is a warning. Processing continues.
User response: Either delete the variable name from the SAVEVAR directive, or make sure you have a
corresponding reference to the variable in the JCL.
EQQJ588E JOB
MEMBER
IN APPLICATION
APPL
IS TOO LARGE TO BE SUBMITTED BY OPC
Explanation: This job exceeds 65 535 records, which is the limit that TME 10 OPC can process.
System action: The job is not submitted. The operation remains in status Arriving or Ready, with extended status
Error during job submission.
User response: Submit the job outside of TME 10 OPC.
EQQJ590E VARIABLE TABLE NAME CONTAINS AN INVALID CHARACTER
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQJ591E THE VARIABLE NAME CONTAINS AN INVALID CHARACTER
Explanation: Data entry error; see “Data Entry Errors” on page 2.
EQQJ592E INVALID VALUE. MUST BE Y OR N
Explanation: Data entry error; see “Data Entry Errors” on page 2.
You can enter only Y (for Yes) or N (for No) in this field.
EQQJ594E THE DEFAULT POSITION MUST BE IN THE RANGE 1-80
Explanation: Data entry error; see “Data Entry Errors” on page 2.
The position you have entered is out of the 80-column range for instream data or a JCL line.
|EQQJ595E VALUE LENGTH IS REQUIRED WHEN COMP.OP IS SPECIFIED
|Explanation: Data entry error; see “Data Entry Errors” on page 2.
|Because you entered a comparison operator, you must enter a value length.
|EQQJ596E COMPARISON OPERATOR REQUIRED WHEN LENGTH IS SPECIFIED
|Explanation: Data entry error; see “Data Entry Errors” on page 2.
|Because you entered a value length, you must enter a comparison operator.
|EQQJ597E THE DEFAULT VALUE IS INVALIDATED BY THE VERIFICATION CRITERIA
|Explanation: Data entry error; see “Data Entry Errors” on page 2.
|The default value that you entered does not comply with the verification rules for the variable.
|EQQJ598E VALIDATION PATTERN IS REQUIRED FOR PICT VERIFICATION
|Explanation: Data entry error; see “Data Entry Errors” on page 2.
|Because you asked for PICT verification, you must enter a validation pattern.
148 TME 10 OPC Messages and Codes