EQQV017E EQQV022E
EQQV017E
NAMEREQ
REQUEST FAILURE - LU/APPLICATION
NODE
NOT ACTIVE
Explanation: The VTAM
NAMEREQ
request failed to complete successfully because the LU-name
NODE
was not
active.
System action: NCF processing is terminated.
System programmer response: Investigate why
NODE
suddenly became inactive. Restart NCF when
NODE
is
active again.
EQQV018E
NAMEREQ
REQUEST FAILURE - VTAM ERROR, OR NCP/VTAM . INCOMPATIBILITY
Explanation: The VTAM
NAMEREQ
request failed to complete successfully because there was an error in VTAM, or
an NCP/VTAM incompatibility. This message is preceded by message EQQV015E in the TME 10 OPC message log.
System action: NCF processing is terminated.
Problem determination: Refer to message EQQV015E to determine the cause of the failure.
System programmer response: Restart NCF when the VTAM errors have been corrected.
EQQV019E SESSION SETUP FAILED - PLU=
LU
NOT AVAILABLE
Explanation: NCF has not been able to establish a session because either:
The TME 10 OPC controller is not started
The NCF task in the TME 10 OPC controller is not available
The LU specified in the SNAHOST keyword of the TRROPTS initialization is not active or is not defined.
NCF retries every 10 seconds until it is successful, or until the subsystem is stopped, or NCF is deactivated.
System action: NCF continues to attempt to establish the LU-LU session.
System programmer response: Review the name specified in the SNAHOST keyword of the TRROPTS
initialization statement. and make sure that it is the correct one. If it is correct, have the system operator at the
TME 10 OPC controller system activate the required resource.
EQQV020I ACB SUCCESSFULLY CLOSED
Explanation: NCF has been successfully disconnected from VTAM.
System action: NCF termination processing continues.
EQQV021W UNABLE TO CLOSE ACB
Explanation: NCF is unable to successfully disconnect from VTAM.
System action: NCF termination processing continues even though the ACB could not be closed.
Problem determination: Most likely a VTAM error has caused this error. Check the system log for VTAM error
messages that can be related to this failure.
System programmer response: None.
EQQV022E LOGON ATTEMPTED BY UNDEFINED LU/APPLICATION
LU
- CLSDST ISSUED
Explanation: A session establishment attempt was made by a remote NCF application unknown to this host TME 10
OPC subsystem. This message is only issued for a NCF application at an TME 10 OPC host.
System action: The request for the session is turned down by issuing a CLSDST macro. Processing continues for
the TME 10 OPC host NCF application.
Problem determination: It is most likely that a name in the ROUTOPTS SNA keyword list of names has been
misspelled, or left out entirely.
System programmer response: Stop the NCF subtask for which erroneous specifications have been given. Correct
the specifications on the ROUTOPTS statement and then restart NCF.
286 TME 10 OPC Messages and Codes