EQQX260E EQQX264E
EQQX260E AN INTERNAL CONTROL BLOCK IS IN ERROR: REASON CODE
XSSRS
Explanation: Validation checking of the data received as input to a routine has detected a damaged control block.
Reason code
XSSRS
provides debugging information. Reason code 102 is given when the dialog code is of an
earlier release than the TME 10 OPC subsystem code.
System action: The request is rejected.
User response: If the reason code in the message is 102, check your ISPLLIB concatenation against the release of
the subsystem you are using. If the error persists, contact your system programmer.
System programmer response: Ensure that the correct load module library is set up to the TME 10 OPC
subsystem and to the user. Check that the library contains the correct version of the TME 10 OPC modules. If the
error persists, collect information in the form of the sequence of actions leading to this error, and if possible, the data it
may be dependent on. Then contact your IBM representative.
EQQX261E NOT ENOUGH STORAGE AVAILABLE: REASON CODE
XSSRS
Explanation: The general service subtask has failed to carry out a request due to failure to allocate enough virtual
storage. Reason code
XSSRS
provides debugging information for IBM personnel.
System action: The request is rejected.
User response: If possible try to limit the storage demand of the request. For example, if this is a request for a list
of operations, choose a narrower selection criteria. If the problem persists, contact your system programmer.
System programmer response: Allocate a larger region to the TME 10 OPC subsystem and then restart the
subsystem. If the error persists, contact your IBM representative.
EQQX262E TIME LIMIT EXCEEDED WHEN TRANSFERRING DATA FROM OR TO THE SUBSYSTEM
Explanation: The request was terminated because the TME 10 OPC subsystem had to wait too long for data to be
transferred to or from the dialog address space. The TME 10 OPC subsystem rejected this request to be able to
service other requests.
System action: The request is rejected.
User response: Try again and if the error persists, contact your system programmer.
System programmer response: Review the TME 10 OPC message log and look for messages concerning the
general service subtask and preceding the long delay. Correct all errors and then restart the TME 10 OPC
subsystem.
EQQX264E THE REQUEST TO CHANGE THE OPERATION FAILED, REASON CODE
XSSRS
Explanation: Your request to change the status of the operation was rejected by the event manager. Reason code
XSSRS
provides debugging information for IBM personnel.
System action: The request is rejected.
User response: Contact your system programmer.
System programmer response: To determine the cause of the error, review the TME 10 OPC message log and
look for messages concerning the event manager and issued at the time of the request. Correct all errors and then
restart the TME 10 OPC subsystem. If you cannot determine the cause of the error and if the error persists, contact
your IBM representative.
340 TME 10 OPC Messages and Codes