Siemens 611-D, 840C 2.6 Loading machine data (as from SW 3)

09.95

SINUMERIK 840C (IA)

2.6 Loading machine data (as from SW 3)

Note Loading the machine data function takes several seconds and is accompanied by

the flashing message “Wait”.

Selection The following softkeys must be pressed: Diagnosis, Startup, Machine data, File

functions:

Fig. 2.2

Procedure

Step Operation Comment

1Activate the standard

data window with the key The window has a yellow border

2Select STANDD_T or

STANDD_M NC-MD The MD in the NCK

area are cleared

3SK Load from disk and assigned stan-

dard values

4Select STANDARD dard values

5SK Load from disk PLC MD, cycl. MD

Initial start-up On initial start-up (state as supplied from Siemens), no files are available in the

“User data” window(see Fig.).

Subsequent start-up On subsequent start-up, user files from the “User data” window can be loaded

instead of the files STANDD_T, STANDD_M, STANDARD in the “Standard data”

window.

Make sure that no communication is taking place with the digital drive systems. If

the user file contains drive data (TEA3), you must acknowledge the drive-specific

2 General Reset and Standard Start-Up

2.6 Loading machine data (as from SW 3)